Get out you hammer, nail gun and hardhat... This course by Jim Pavett will teach you how to take your initial studio design and transform it into the actual floors, walls and ceilings of your recording studio!
This course assumes that you've watched the Studio Edge 101 course and have got your basic plan in place. Now it’s time to solidify the design and start the construction!

The first section is all about design. Here you learn about the different kinds of spaces—from the Writing Room to the Control Room—and how they work together in the overall design. Next, you’re off to construction: In this collection of tutorials you get the inside info on the different construction materials you need to build your floors, walls, ceilings, doors and windows.

Next up is HVAC and electrical. These essential components must follow very specific design criteria to ensure that your studio is comfortable, acoustically quiet and free of those pesky grounding problems. Jim shows you the concepts to insure making that your studios mechanicals are top notch.

Wall treatments and isolation tips is next: In these tutorials, Jim takes you on a tour of some commercially available acoustic materials, explains what they do and shows you several different mounting techniques to help you balance out the absorptive, diffusive and isolation needs of your recording environment.

Now it’s time to move in your gear and set up the monitors. In this series of tutorials you learn how to spec out your gear, get everything wired up and ready to rock! However, before you can book your first session, you’ve got to fine tune the room! The final tutorials in this course explore all the parameters that must work together to get your studio sounding just right!

So before you build your first wall, sit back and be sure to watch all of the courses and videos in our Studio Design and Construction collection to get the job done right!

Table of contents:

1. Different Designs for Different Needs
2. Creating the Writing Room
3. Using Technology When You Can't Build
4. Designing the Control Room and Live Room
5. Designing the Small Isolation Room
6. Send Off Design for Analysis
7. Selecting Equipment
8. Studio Wiring and Patch Layouts
9. Physical Construction
10. Construction Materials
11. Wall Performance
12. Floor Construction
13. Wall Construction
14. Ceiling Construction
15. The Doors
16. Windows - Outdoor and Observation
17. HVAC System
18. Electrical System and Grounding
19. Treating the Room
20. Isolation Tools
21. Equipment Installation
22. Techin' Out the Install
23. Speaker Setup
24. Acoustic Analysis
25. What does and Acoustician do?
26. Diagnosing the Problems
27. Room Modes
28. Comb Filtering
29. Absorption
30. Diffusion
31. Speakers
32. Benefits
33. Control Room Analysis and Results
34. Conclusion