DIY Thermometer for direct environmental measurements
Detailed App Info:
Application Description
To operate this app you need some additional hardware option that you have to connect to the headphone connector via a 4 pin plug. All you have to do in this little DIY project is to connect a NTC 10hOhm thermistor, a 0.1uF cap and a 180Ohm resistor to the plug. The circuit is shown within the help page of the app.
DISCLAIMER
To run this app a DIY hardware option is required as described above
This app is only for experimental, hobby and educational use. This is not a precise approved instrument and may not be used to perform serious temperature measurements and human use.
Please contact us for any questions
HMB|TEC
info@hmb-tec.de
Requirements
Your mobile device must have at least 1.78 MB of space to download and install DIY Thermometer for direct environmental measurements app. DIY Thermometer for direct environmental measurements was updated to a new version. Purchase this version for $2.99
If you have any problems with installation or in-app purchase, found bugs, questions, comments about this application, you can visit the official website of HMB-TEC Holger Blümler at http://hmb-tec.de/iPhoneApps/thermometer.html.
Copyright © HMB-TEC Holger Bluemler